View complete catalog page

Note about gage length on Dual Contact steep taper tool holders
Steep taper tool holders are originally designed as a taper contact only interface. The gage line is determined by measuring the distance from a standardized, known reference diameter on the taper. This point is called the gage line. In most cases, this is around the same area where you can see the grind relief on the precision ground taper, close to where the flange starts.

Since development of the dual contact system in the early 1990's newer tool holders with the dual contact option have a precisely ground flange shoulder for attaining a dual contact fit with the spindle face. This precise shoulder is not at the same location as the gage line! Gage line is still measured and calibrated like a standard steep taper tool holder. Please do not measure probe tip to flange and think that your tool has been improperly made. Thank you.

• Works on all CAT 40 machines with Dual Contact Spindles
• Compatible with BIG-PLUS® spindles
• This tool is to be used as a standard for gage length
• Can be used to calibrate your table tool probe
• Can be kept in tool changer for periodic probe calibration
• All critical tool holder surfaces precision ground
• Made from alloy steel hardened to 54 - 56rc
• Gage length is 4.000 inches*
• Probe diameter is .3000 inches*
• Individual calibration certificate is included with each tool holder
• Concentricity of probe diameter is .0001 inches or less
• Rear thread for pull stud is 5/8—11
• MariTool Part# is CAT40-TPC.3-4.0D

*BIG-PLUS® is a trademark of Daishowa Seiki Kabushiki Kaisha; Big Daishowa Seiki Co., Ltd., Corp.
Compatible with BIG-PLUS® spindles, but not licensed.

*All calibrated measurements are laser marked on each tool